Rane FT 45 Fader Bedienungsanleitung PDF herunterladen

FT 45

CROSSFADER

10024

2. Remove the four screws securing the

cover plate (see Figure 1) with a #1

3. Carefully remove cover plate.

4. Remove the two mounting screws (shown

in Figure 2) with a #1 screwdriver,

while holding the fader in place.

5. Slide fader to one side and bring through

hole in panel.

6. Remove ribbon cable from the fader

Fader Removal

supplied with the replacement

5. Install the four new mounting screws

with the replacement fader. (see

2. Feed replacement fader through hole.

1. Plug ribbon cable onto fader assembly.

3. While holding fader in place, install

Fader Installation

the two mounting screws supplied

Phillips screwdriver.

assembly.

fader. (see Figure 1).

4. Carefully place the cover plate back

onto unit.

Figure 2)

1. Remove the three fader knobs by

gently pulling up.

6. Place the three knobs back onto the

faders.

Figure 1

102401

Figure 2

TTM 54 PERFORMANCE MIXER

FT 45CROSSFADER100242. Remove the four screws securing the cover plate (see Figure 1) with a #13. Carefully remove cover plate.4. Remove the two mou

Keine Kommentare

Rane FT 45 Fader Bedienungsanleitung