Rane MX 23 Bedienungsanleitung PDF herunterladen

Manual-1

QUICK START

Whoa, hold on there. Even if you don’t read manuals as a matter of principle, at least read this section to avoid hurting

yourself or your equipment.

Connect the MX 23 with the POWER off. Balanced XLR cables are recommended, but if you must convert to ¼"

connectors, buy or make a cable like the ones on page Manual-11 and keep them as short as possible. This device uses low

impedance balanced line drivers. Do not connect the “+” or “–” output pins to ground, as this may cause the power supply

to shut down. For unbalanced use, leave the unused output pin (“+” or “–”) unterminated.

Consult the speaker manufacturers for the correct crossover FREQUENCY settings. As rugged as some drivers are,

many (especially compression drivers) will not accept frequencies outside of their normal range without producing distor-

tion and possibly self-destruction.

With all equipment turned off and LEVEL controls down, begin making connections to the system as shown on page

Manual-4 or 5. When turning on the system, switch on the power amplifiers last. Now, feed the MX 23 some program

material. Start by turning up the LOW LEVEL, MID LEVEL and HIGH LEVEL to the 0 dB marks. Slowly increase the

INPUT LEVEL, even if it goes all the way to 10, so the +4 dBu (green) light blinks occasionally and the OL (red) light

stays out. This delivers the best signal-to-noise performance.

The MONO SUB OUTPUT is a sum of the Left and Right Low Outputs. The MONO SUB LEVEL adjusts only this

Output and is not affected by the LOW LEVEL control.. When using a single mono bass bin along with stereo mid- and

high-range cabinets, set the 100 Hz FILTER to OUT, allowing the front panel FREQUENCY to control the subwoofer

crossover point. When used with 3-way cabinets and a subwoofer, set the 100 Hz FILTER switch to IN to allow only

frequencies below 100 Hz at this output jack. This way, the MX 23 almost does the job of a Stereo 4-Way crossover, but

without removing that awesome bass from the Left and Right Low Outputs.

WEAR PARTS: This product contains no wear parts.

OPERATORS MANUAL MX 23

STEREO 3-WAY CROSSOVER

1 2 3 4 5 6 7 8 9

Inhaltsverzeichnis

Seite 1 - OPERATORS MANUAL MX 23

Manual-1QUICK STARTWhoa, hold on there. Even if you don’t read manuals as a matter of principle, at least read this section to avoid hurtingyourself o

Seite 2 - IMPORTANT SAFETY INSTRUCTIONS

RISK OF ELECTRIC SHOCKDO NOT OPENCAUTIONTo reduce the risk of electrical shock, do not open the unit. No user serviceable parts inside. Refer servicin

Seite 3

Manual-2HIGH OUTPUTSThese are balanced Output jacks. Connectthe LEFT HIGH OUTPUT to the left channelinput of the high frequency amplifier, andthe RIGH

Seite 4

Manual-3Power ON switch and LEDYour basic, straightforward power switch.When the yellow LED is lit, the MX 23 isready to go.MID/HIGH FREQUENCYcontrolT

Seite 5

Manual-4APPLICATION — ACTIVE 3-WAY WITH (or without) MONO SUBConnect as shown for a mono subwoofer. Set the 100 Hz FILTERswitch to the IN position. If

Seite 6 - OPERATING INSTRUCTIONS

Manual-5Setting the Output Level ControlsThe INPUT LEVEL is an overall system sensitivityadjustment. Use this control to decrease the overall sensitiv

Seite 7 - Manual-6

Manual-6Setting the Mono Sub Output LevelBegin with the MONO SUB OUTPUT LEVEL trim set atMAX. The LOW LEVEL control has no affect on the MONOSUB OUTPU

Seite 8 - SOUND SYSTEM INTERCONNECTION

Manual-7SOUND SYSTEM INTERCONNECTIONproperly, connecting both ends of the shield is not oftenpracticed, since doing so can create noisy interconnectio

Seite 9 - VARIOUS XLR CABLE ASSEMBLIES

Manual-8©Rane Corporation 10802 47th Ave. W., Mukilteo WA 98275-5098 TEL (425)355-6000 FAX (425)347-7757 WEB http://www.rane.comVARIOUS XLR CABLE

Kommentare zu diesen Handbüchern

Keine Kommentare

Rane MX 23 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Audio Rane MX 23 herunter. Rane MX 23 User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Audio Rane MX 23