Rane RPE 228d Bedienungsanleitung PDF herunterladen

Manual-1

OPERATORS MANUAL RPE 228d

PROGRAMMABLE EQUALIZER

QUICK START

Read this section if you want to install and operate the RPE 228d without wading through the detailed descriptions in

this manual. If the control software has not yet been installed on your computer, refer to SOFTWARE OPERATION on

page Manual-5 first.

Turn the amplifier(s) down or off until all connections are complete. Connect balanced audio INPUTS and OUTPUTS

to the handy Euroblock connectors on the rear. Connect the RW 232 INPUT jack on the rear to a serial (COM) port on a

PC-compatible computer using a standard 9-pin RS-232 cable (a short one is supplied with the unit, which is intended to

connect between units in a rack). The cable or adaptor must not be a null-modem type.

Locate the RW 232 DEVICE ADDRESS switch on the rear panel. If this unit is to be tested by itself, set it to ‘1’ by

setting all switches off (down), except switch one (labeled ‘1’ on the chassis, the right-most switch). If there is more than

one unit, refer to SETTING THE DEVICE ADDRESS to set a unique number (see page Manual-4).

Apply power by connecting the RS 1 remote power supply to the red telephone-style jack on the rear of the unit.

CAUTION: don’t connect anything but an approved RANE power supply to this jack. If the RS 1 and the RPE 228d are

getting power, the front panel yellow POWER light will be on.

Start your computer, run Windows

, and launch our software by double-clicking on the RaneWare

icon. The System

Setup window may appear. If it doesn’t, select System Setup from the Setup menu. Be careful to select the COM port

which is physically connected to the RPE 228d. Click OK. Now, the Device Selection window may appear. If it doesn’t,

choose Select from the Device menu. Click on Poll, … and the Devices Found will display the number of units found.

Click the Stop button. Select the unit listed in the Device Selection window and click OK. If no unit was found, please

refer to the TROUBLESHOOTING section.

Several clues indicate communication between the computer and the RPE 228d. The yellow COM (communications)

light on the unit should flash periodically. The Memory numbers (1-16) near the top of the computer screen should be

black rather than grey. Clicking the BYPASS button on the screen causes one Channel of the unit to enter Bypass mode.

WEAR PARTS: This product contains no wear parts.

Windows

is a registered trademark of Microsoft Corporation.

RaneWare is a registered trademark of Rane Corporation

1 2 3 4 5 6 7 8

Inhaltsverzeichnis

Seite 1 - OPERATORS MANUAL RPE 228d

Manual-1OPERATORS MANUAL RPE 228dPROGRAMMABLE EQUALIZERQUICK STARTRead this section if you want to install and operate the RPE 228d without wading th

Seite 2 - RPE 228d CONNECTION

Manual-2FRONT PANEL DESCRIPTION햲 BYPASS (red) lights whenever the audio relay Bypass for the Channel is active. This occurs for a few seconds after po

Seite 3 - MEMORY RECALL PORT

Manual-3REAR PANEL DESCRIPTION햲 Remote POWER jack is for connection to a Rane RS 1 or compatible power supply. Units with outboard power supplies dono

Seite 4 - SETTING THE DEVICE ADDRESS

Manual-4SETTING THE DEVICE ADDRESSThe Device Address is set using a binary code which may be determined using the following table,our Windows Address

Seite 5 - SOFTWARE OPERATION

Manual-5RANEWARE REQUIREMENTS• RaneWare works under Microsoft Windows 3.1, 95, 98 orNT® on a PC or laptop with an available serial port. Note:Windows

Seite 6 - Manual-6

Manual-6Changing curvesGo ahead, grab any slider with themouse cursor. An accurate representationof the full audio frequency response isportrayed in t

Seite 7 - Manual-7

Manual-7This selection allows you to enter the Project name,installation Site and System Engineer for a given project. Allof these are printed on the

Seite 8 - TROUBLESHOOTING

Manual-8Windows 95/98/NT UsersIf you find yourself squeezed for room at the bottom ofthe screen, you can modify the Task Bar so it only appearswhen yo

Kommentare zu diesen Handbüchern

Keine Kommentare

Rane RPE 228d Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Audio Rane RPE 228d herunter. Rane RPE 228d User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Audio Rane RPE 228d