Rane RE 27 Bedienungsanleitung Seite 3

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 6
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 2
Manual-3
REAR PANEL DESCRIPTION
RA 30 CONNECTION
SYSTEM HOOK-UP
Connect the RA 30 into your system as shown below. Plug
the Rane condenser microphone into the front panel MIC
INPUT. CAUTION: Do not plug any other microphone into the
front panel jack: This jack contains a T-power DC voltage
which may be damaging to other microphones.
POWER input connector: Use only a model RS 1 or other power supply approved by Rane. This unit is supplied with a remote
power supply suitable for connection to this input jack. This is not a telephone jack. The power requirements call for an 18 VAC
center-tapped transformer only. Using any other type of unapproved supply may damage the unit and void the warranty. Two
years parts and labor is worth safeguarding.
Chassis ground point: A #6-32 screw is used for chassis grounding purposes if needed.
PINK NOISE OUTPUT jack: This is an unbalanced ¼" jack which supplies Pink Noise to the sound system.
PINK NOISE LEVEL adjust: Use a 3/16" or smaller screwdriver to adjust the output from the Pink Noise generator to match
the input level requirements of the mixer or other equipment.
LINE INPUT jacks: These are balanced ¼" TRS Inputs, but unbalanced ¼" TS connections will work. When mono VU
metering is desired, only use the LEFT Input. Front panel SOURCE switch must be in LINE IN to activate these jacks.
AUX MIC INPUT jack: A balanced female XLR connector for receiving signals from a low impedance microphone. Pin 2 is
“hot” or (+). Use this jack when you wish to use a microphone other than the one supplied. Front panel SOURCE switch must be
set to AUX MIC for this jack to be active. If your mic requires phantom power, an external supply must be used.
600mA
POWER
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
POSITIVE
NEGATIVE
CHASSIS GROUNDPIN 1
PIN 3
PIN 2
OUTPUT
PINK NOISE LINE IN AUX MIC
RA 30
LEVEL
CLASS 2 EQUIPMENT UNBAL
N108
BAL/UNBAL
OL
BALANCED
LEFT/MONORIGHT GAIN
RANE CORP.
MADE IN U.S.A.
DRIVER
LOW
HI DRIVER
LINE INPUT
CROSSOVER
MIXER
HI AMP
LOW AMP
MIC 2
CAL MIC INPUT (FRONT PANEL)
MAIN OUTPUT
AUX OUTPUT
EQUALIZER
600mA
POWER
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
POSITIVE
NEGATIVE
CHASSIS GROUNDPIN 1
PIN 3
PIN 2
OUTPUT
PINK NOISE LINE IN AUX MIC
RA 30
LEVEL
CLASS 2 EQUIPMENT UNBAL
N108
BAL/UNBAL
OL
BALANCED
LEFT/MONORIGHT GAIN
RANE CORP.
MADE IN U.S.A.
Seitenansicht 2
1 2 3 4 5 6

Kommentare zu diesen Handbüchern

Keine Kommentare