Rane MLM 103 2000 version Bedienungsanleitung PDF herunterladen

Manual-1

MLM 103

MIC/LINE MIXER

OPERATORS MANUAL

WEAR PARTS: This product contains no wear parts.

MLM 103 CONNECTION

INPUTS

The MLM 103 has ten balanced Euroblock Inputs. Use

only shielded cable. For best noise rejection use two-conduc-

tor-plus-shielded wire, even for unbalanced operation.

Connect the non-inverting (positive) audio lines to the “+”

terminals, and the inverting (negative) lines to the “–”

terminals. Connect the shields to the “ground” terminals.

For those installations where the MLM 103’s internal

shield-to-chassis connection causes interference, connect the

shields directly to chassis PEM nuts directly above each pair

of Euroblock connectors. Be sure to bite through the paint

with the star washer and keep the shields wrapped around the

audio conductors as much as possible. For the “theoretical”

best ElectroMagnetic Interference (EMI) immunity, connect

the shields at both ends of the cables. (For more information

on connections, see RaneNote 110, “Sound System Intercon-

nection” later in this manual or on Rane’s web site.)

MONO INPUTS 1-6 can accept either mic or line level

sources. When connecting line level signals, push the rear

panel button in for LINE. For mic signals, be sure the button

is in the MIC (out) position.

STEREO INPUTS 7/8 and 9/10 accept line level stereo

and mono sources.

OUTPUTS

The MLM 103’s OUTPUTS (and DIRECT OUTPUTS)

are balanced. The same wiring conventions as the Euroblock

Inputs apply.

QUICK START

If you don't get any further, at least read this section to get the best gain structure out of the MLM 103.

INPUTS 1 through 6 may be microphone or line level. The choice between the two is made by setting the Input’s LINE

push-button on the rear panel.

Push the PHANTOM POWER button (when needed) for each pair of Inputs.

Using a screwdriver, adjust the TRIM for each Input so that the front panel OL LED illuminates only occasionally

during extreme peaks. The three-band Equalizer settings will influence this, so keep an eye on the OL when making EQ

adjustments. Now adjust the LEVEL for each Input.

Assign each Input to the desired Output by pushing any combination of the A, B, or AUX ASSIGN buttons.

INPUTS 7/8 and 9/10 are stereo line level Inputs.

Assign each stereo input to the desired output as follows:

When the A/B ASSIGN button is engaged and the MONO button is not engaged, INPUT 7 (or 9) is routed to the A

Output, while INPUT 8 (or 10) is routed to the B Output.

When the both the A/B ASSIGN and MONO buttons are engaged, both Inputs of 7/8 (or 9/10) will route to both the A

and B Output.

The AUX ASSIGN button is always a mono mix of the stereo channel.

1 2 3 4 5

Inhaltsverzeichnis

Seite 1 - OPERATORS MANUAL

Manual-1MLM 103MIC/LINE MIXEROPERATORS MANUALWEAR PARTS: This product contains no wear parts.MLM 103 CONNECTIONINPUTSThe MLM 103 has ten balanced Euro

Seite 2 - FRONT PANEL DESCRIPTION

Manual-2FRONT PANEL DESCRIPTION햲 Equalizer level controls are used to contour the frequency response of the desired Input.햳 Mic/Line OUTPUT ASSIGN but

Seite 3 - REAR PANEL DESCRIPTION

Manual-3REAR PANEL DESCRIPTION햲 MIC/LINE INPUT TRIM controls 1-6 adjust the input gain of the Mic/Line Inputs. The gain range for Mic level is 12 to60

Seite 4 - MLM 103 OPERATION

Manual-4©Rane Corporation 10802 47th Ave. W., Mukilteo WA 98275-5098 TEL (425)-355-6000 FAX (425)-347-7757 WEB http://www.rane.com104623MLM 103 O

Seite 5 - IMPORTANT SAFETY INSTRUCTIONS

RISK OF ELECTRIC SHOCKDO NOT OPENCAUTIONTo reduce the risk of electrical shock, do not open the unit. No user serviceable parts inside. Refer servicin

Kommentare zu diesen Handbüchern

Keine Kommentare

Rane MLM 103 2000 version Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Audio Rane MLM 103 2000 version herunter. Rane MLM 103 2000 version User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Audio Rane MLM 103 2000 version