Rane MM 12 Bedienungsanleitung PDF herunterladen (Seite 12)

set of headphones into the MM 12 to monitor BOTH the house mix and the monitor mixes as

necessary. Whenever any of the MM 12 CUE buttons is depressed, you will hear the mix in that

monitor. When none of the MM 12 CUE buttons are depressed, you wiII automatically hear the

house mix from the main mixer, allowing you to use the main mixer cue system without

switching the headphones back and forth between mixers (slick, no?).

B. USING THE HEADPHONES MAINS INPUT FOR INPUT CUEING.

You may use the

MAINS INPUT in the headphone section of the MM 12 to verify any input to the MM 12 or

make tone adjustments during the performance.

1. Obtain a stereo 1/4" PATCH CORD at least 18” long.

2. Remove the case from one of the stereo plugs on this cord: using a small piece of wire,

connect the TIP lug to the RING Iug so that the TIP and RlNG are shorted together but remain

isolated from the GROUND. By doing this, the SEND and RETURN in the MM 12 LOOP jack

will remain connected when this special cable is inserted. preventing signal loss at the MIX

LEVEL controls.

NOTE:

If a mono patch cable or un-modified stereo patch cable is plugged into the LOOP

jack on any input, the SEND/RETURN link will be interrupted and that channel will no longer

be present in the output mixes.

3. Plug one end of your modified cable into the MAINS input on the MM 12 headphone

section: then plug the other end into any of the input LOOP jacks to listen to the input program

without interrupting monitor mix content.

BEWARE: The MM 12 has a powerful headphone amplifier—keep the headphone volume

control turned down before plugging into the LOOP jacks. A sudden blast in the headphones

when plugging in just might render you cross-eyed for several minutes.

IV-S. USING THE EXPAND INPUTS. Expand inputs are provided on the MM 12 to enable

two MM 12’s to be used "piggy-back" for 24 inputs into 6 outputs. Simply plug the OUTPUTS

of one MM 12 into the EXPAND inputs of the second MM 12 and you will have 24-in/6-out

with the same layout logic. Use the following procedure:

1. Plug the OUTPUTS of one MM 12 into the EXPAND inputs of the second MM 12.

2. Plug the OUTPUTS of the second MM 12 into the monitor amplifiers.

3. Set the MASTER level controls of the first MM 12 to full output level; then use only the

MASTER levels of the second MM 12 to control the volume in each of the monitor speakers.

Now each of the six monitor speakers will have 16 MIX LEVEL controls. Use the submixing

capability of each MM 12 to best suit your needs as described in Section IV-1A.

5. Whenever possible, locate the first MM 12 ABOVE the second MM 12 to maintain the

vertical columns of MIX LEVEL knobs for each monitor speaker.

6. In using two MM 12s. you now will have TWO two-stage parametric equalizers for each

monitor speaker, giving you greater feedback control. Use the parametrics as outlined in

Section IV-3.

1 2 ... 7 8 9 10 11 12 13

Keine Kommentare

Rane MM 12 Bedienungsanleitung Seite 12