OWNER’S MANUAL
28
SIXTY-FOUR
MIDI Configuration Screen
• When Receive MIDI Beat Clock is checked, the
mixer receives MIDI real time system messages.
• When Send MIDI Beat Clock is checked, the
mixer sends MIDI real time system messages.
• When User Button Lighting is checked, the
mixer will not automatically light button LEDs for
momentary presses. Enable this option if you
wish to send MIDI commands to the mixer from
3rd-party software to control button LEDs.
Factory Defaults
To reset a Sixty-Four Mixer to its default settings:
• Power off the Sixty-Four.
• Push both Deck 1 FlexFX and Deck 2 FlexFX buttons at the same time.
• While holding these buttons down, power on the Sixty-Four.
• Immediately after fading up, the FlexFX lights ash bright one time, indicating a successful reset.
To check the mixer's current rmware version, press and hold Shift then press Non PGM MIDI.
MIDI Mapping
Mic Bypass Mode
All controls on the mixer are MIDI mappable, including the Mic sections. If you do not use the Mic
sections, you can independently bypass the controls so they do not affect audio, and only output their
MIDI changes. This allows you to map the Mic controls to functions in software, such as effects, and not
have to worry about introducing noise in your mix from a oating Mic input.
To toggle Mic Bypass Mode, hold the Shift button and press the Mic On button
for the Mic section you wish to bypass. That button will start ashing lightly,
indicating those audio controls are now bypassed and are only outputting MIDI
changes. The Mic On and FlexFX buttons, as well as the Level, Pan, and Tone
controls are affected by this mode. While bypassed, the FlexFX and Mic On
buttons will ash with momentary button presses, but the LED state cannot be
set from software like the side strip controls. Holding the Shift button and pressing the Mic On button
again will exit Mic Bypass Mode, returning the Mic section to regular operation. The Mic On button will
return to the ‘off’ state.
Be sure to reset the Level, Pan, and Tone controls to appropriate values before switching the Mic back on.
Top Panel Map
In the following diagrams, green equals Control Change and blue equals Note On/
Off. All control changes are single precision, 0x00 to 0x7F (0 to 127 dec). As noted,
all software controls on the two side strips are routed to USB Port A or USB Port B
according to Deck input selectors. All other controls dedicated to mixer functions are
sent to USB Port A or USB Port B according to the Non PGM MIDI button located
under the Main Mix meter. Toggle between Green for USB Port A and Orange for USB Port B.
SHIFT
ON
MIC
BA
NON PGM MIDI
(16 Seiten)
(11 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern