OWNER’S MANUAL
27
SIXTY-FOUR
Deck Inputs 1-4 Screen
There is one panel for each input channel on the
mixer. Each Deck panel controls these functions:
Analog Input Source: The analog input for each
channel may be set for Line level (CD) or Phono
level (PH) using a switch on the rear of the mixer.
The control panel shows the mode selected on the
mixer for each of the four inputs. This mode can
only be changed on the mixer.
Phono Sensitivity: If Phono Input is selected on
the mixer (as shown for Deck 3) the Phono Sensitivity adjustment appears in the panel. Click the down-
arrow to display a list of 16 sensitivity settings between 2.5 mV and 10 mV in 0.5 mV steps. The default is 5
mV. Set the Phono Sensitivity to the same level of your cartridge (see your cartridge documentation for the
correct value). Another method is to match the level of a CD on another input.
Filter Resonance: Each input channel has a Filter knob that provides high-pass and low-pass ltering.
Filter resonance controls the “peak” of the lter cutoff frequency. The Low setting provides the smoothest
Filter without adding gain. The High setting adds accent to frequencies near the Filter cutoff point by
adding about 12 dB of gain. Adding gain in a narrow peak around the cutoff frequency adds a “zippy
whistle” effect to audio as the Filter is swept. The default is 5 dB.
USB Record Source: These controls select one of two sources for each input channel as the USB record
source. The PH / CD source must be selected for DVS control. When DVS is not used, a record source
may be set to Post-fader to allow multi-channel recording of a set.
Effects Screen
The Filter panel selects the lter type and sync
mode:
• High-pass Filter with high-frequency sync.
• High-pass Filter with low-frequency sync.
• Low-pass Filter with high-frequency sync.
• Low-pass Filter with low-frequency sync.
The Flanger panel selects a feedback mode:
• Positive feedback.
• Negative feedback.
The Echo panel selects one of four echo modes.
• Echo with no feedback lter and adjustable recirculation 0 to 70%.
• Hold Echo with no feedback lter and adjustable recirculation of 0% to 100%.
• Low-cut Echo with adjustable feedback lter and adjustable recirculation 0 to 70%.
• Low-cut Hold Echo with adjustable feedback lter and adjustable recirculation of 0% to 100%.
• The sliders set the low-cut lter cutoff frequency
The Analog Insert panel has two options. We recommend the +4 dBu setting unless you insert a low-
voltage device using RCA connectors.
• +4 dBu.
• -10 dBV.
(16 Seiten)
(11 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern