Rane SP 15 Betreibershandbuch PDF herunterladen (Seite 15)

• USB-3 (5-6) Record Source: This

control allows users to select one of two

analog sources as the vinyl emulation or

USB record source for PGM 1. The two

radio buttons allow the user to select

PH/CD 1 or PH/CD 2. The post PGM

1 fader signal is always available for

recording on USB 1 (1-2) record.

• USB-4 (7-8) Record Source: This

control allows selecting one of two

analog sources as the vinyl emulation

or the USB record source for PGM 2.

The two radio buttons allow the user to

select PH/CD 3 or PH/CD 4. The post

PGM 2 fader signal is always available

for recording on USB 2 (3-4) record.

Effects Page Controls:

The Filter panel has four radio buttons

allowing users to select lter type and

sync mode:

• High-Pass Filter with high-frequency

sync.

• High-Pass Filter with low-frequency

sync.

• Low-Pass Filter with high-frequency

sync.

• Low-Pass Filter with low-frequency

sync.

The Flanger panel has two radio buttons

allowing users to select one of two

feedback modes:

• Positive feedback.

• Negative feedback.

The Echo panel allows users to select

one of four echo modes:

• Echo with no feedback lter and

adjustable recirculation 0 to 70%.

• Hold Echo with no feedback lter

and adjustable recirculation of 0% to

100%.

• Low-Cut Echo with adjustable

feedback lter and adjustable

recirculation 0 to 70%.

• Low-Cut Hold Echo with adjustable

feedback lter and adjustable

recirculation of 0% to 100%.

• The sliders in the control panel set

the low-cut lter cut off frequency.

Echo Default Effects settings are:

• Low-Pass Filter with high-frequency

sync.

• Flanger with positive feedback.

• Echo with no feedback lter.

• Echo lter frequencies default to 82

Hz.

The Analog Insert panel has two options:

• +4 dBu

• -10 dBV

We recommend the +4 dBu setting unless

you insert a low-voltage device, in which

you should use the -10 dBV setting.

MIDI Conﬁguration Page:

• When Receive MIDI Beat Clock is

checked, the mixer receives MIDI Real

Time System Messages.

• When Send MIDI Beat Clock is

checked, the mixer sends MIDI Real

Time System Messages.

• When User Button Lighting is checked,

the mixer will not automatically light

button LEDs for momentary presses.

Enable this option if you wish to send

MIDI commands to the mixer from third-

party software to control button LEDs.

Factory Defaults

To reset the Sixty-Two Mixer’s:

• Record/Control Sources

• LP/HP Filter Resonances

• Filter Type, Flanger and Echo effects

to factory default settings:

1. Power off the Sixty-Two.

2. Push both PGM 1 and 2 FLExFx buttons

at the same time.

4. While holding these buttons down,

power on the Sixty-Two.

5. Immediately after fading up, the FLExFx

lights ash one time, indicating a

successful reset.

NOTE: Settings are saved in the mixer.

Software is updated with the mixer’s

settings. Therefore, the mixer may

replace control source and effect

settings in Scratch Live or software

control panels with current mixer

settings that may have been changed

by a different laptop.

RANE SIXTY-TWO MIXER FOR SERATO SCRATCH LIVE • OPERATOR’S MANUAL 2.5.0

15

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 59 60

Kommentare zu diesen Handbüchern

Keine Kommentare