Rane SR 2 Bedienungsanleitung PDF herunterladen (Seite 20)

Manual-20

e SR 2 responds with response data based on the commands/arguments it was

sent. e SR 2 limits its response data to 40 characters. In the case of an error, the

response data is: n,"ERROR" where n is an error code dened below:

Hex ASCII Error Code Meaning

$31 '1' Sent <devtype> invalid.

$32 '2' Sent <checksum> did not verify.

$33 '3' Sent <command/data> parse error.

$34 '4' Sent <command/data> greater than 40 characters, or

the number of concatenated commands >4.

$35 '5' Response <command/data> greater than 40 characters.

See the SR 2 Command Set section below for details of valid SR 2 responses.

<CR> A carriage return ($0D) terminates every message.

SR 2 Command Set

is section details the <command/data> portion of a complete RW 485 mes-

sage. e SR 2 supports 10 commands. Below is a table of commands and associ-

ated responses, followed by descriptions.

Conguration Commands

Cmd Arg(s)* Description Response**

V Get Firmware, Hardware Version n1,n2,"OK"

N ["ccc…"] Read/Write Device's Name "ccc…","OK"

SPL n1[,n2] Read/Write Stored Parameter n,"OK"

Input Commands

ILD [n1] Read/Write LED Enable n1,"OK"

ILK [n1] Read/Write Input Lock n1,"OK"

IQ Input Query n1,n2,"OK"

IR Input Raw n1,n2,n3,n4,"OK"

IS n1,n2 Input Suggest n1,n2,"OK"

ISR n1,n2 Input Suggest Raw n1,n2,n3,n4,"OK"

IF n1,n2 Input Force "OK"

* [ ] denotes optional Command Argument

** Responses from concatenated commands produce

only one "OK"

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 35 36

Keine Kommentare

Rane SR 2 Bedienungsanleitung Seite 20