Rane MPE MIDI Programmable Equalizer Bedienungsanleitung PDF herunterladen (Seite 17)

Rane MPE Users Guide

Enabling Parameter Echo

1. Make sure you’re in Normal Operating mode,

then enter the Set Parameter Echo function by

pressing F-PARAM. The FUNCTION LED

illuminates, and the PARAM LED flashes to

verify that you are in this function. The current

Parameter Echo status occupies the SYSTEM

display (onon or offoff).

2. Use the UP or DOWN key to toggle the status of

Parameter Echo on or off.

3. Press F-PARAM to return to Memory mode

when you are finished. The FUNCTION and

PARAM LED’s turn off.

Dumping The MPE Memory Via MIDI

SYSEX

The MPE dumps (transmits) the contents of its

Working Memory, Stored Memory, or MIDI map in

the form of a MIDI SYSEX message at your com-

mand. A device tuned to the same MIDI channel and

device ID will receive the dump. This is particularly

useful if you wish to save the contents of an MPE’s

memory, or to fill one MPE with the exact memory

contents of another.

To dump MPE memory:

1. Make sure you’re in the Normal Operating mode,

and then enter the Dump Memory function by

pressing F-DUMP. The FUNCTION LED

illuminates and the DUMP LED flashes, indicat-

ing you are in this function (see the figure below).

The SYSTEM display indicates the default

parameters the MPE will dump.

2. Use the UP or DOWN key to choose which of

the MPE parameters you wish to dump. They

will be displayed as cuRcuR (CURRENT Working

Memory), allall (all of Stored Memory), or

mapmap (MIDI map).

3. Once you have selected the parameters for regur-

gitation, press F-DUMP to execute the dump and

return to Normal Operating mode, or the

MEMORY key to abandon the dump and return

to Normal Operating mode. The FUNCTION

and DUMP LED’s turn off.

Since there is a lot of Stored Memory, the allall

dump takes approximately two seconds to complete.

The allall dump is executed in four pieces, each

one about 1200 bytes long. If your receiving device

can not handle a 1200 byte message, then you must

send Stored Memory manually. This is accom-

plished by recalling each Stored Memory, one at a

time, and storing it back to the same spot with

Parameter Echo on. Parameter Echo sends the new

Stored Memory via MIDI SYSEX. This may be

tedious, but it’s the receiving device’s fault. MPE’s

handle the entire data burst with no problem.

If you want to send all three sets of parameters

(Working Memory, Stored Memory, and MIDI map)

execute each dump individually.

An MPE receives a memory dump only if the

MIDI channel and device ID on each unit match, just

as with any other MIDI SYSEX message. The

dumper and dumpee must be the same model.

That about does it for operation of the MPE. If

you followed everything we’ve discussed so far, you

are well on your way to becoming a Zen master

ninja MPE operator.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 33 34

Kommentare zu diesen Handbüchern

Keine Kommentare

Rane MPE MIDI Programmable Equalizer Bedienungsanleitung Seite 17

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Audio Rane MPE MIDI Programmable Equalizer